Steep transistors: The ability to scale a transistor’s supply voltage is determined by the minimum voltage required to switch the device between an on- and an off-state. The sub-threshold slope (SS) is the measure used to indicate this property. For instance, a smaller SS means the transistor can be turned on using a smaller supply voltage while meeting the same off current. For MOSFETs, the SS has to be greater than ln(10) × kT/q where k is the Boltzmann constant, T is the absolute temperature, and q is the electron charge. This fundamental constraint arises from the thermionic nature of the MOSFET conduction mechanism and leads to a fundamental power/performance tradeoff, which could be overcome if SS values significantly lower than the theoretical 60-mV/decade limit could be achieved. Many device types have been proposed that could produce steep SS values, including tunneling field-effect transistors (TFETs), nanoelectromechanical system (NEMS) devices, ferroelectric-gate FETs, and impact ionization MOSFETs.
Spin devices: Spintronics is a technology that utilizes nano magnets’ spin direction as the state variable. Spintronics has unique properties over CMOS, including nonvolatility, lower device count, and the potential for non-Boolean computing architectures. Spintronics devices’ nonvolatility enables instant processor wake-up and power-down that could dramatically reduce the static power consumption. Furthermore, it can enable novel processor-in-memory or logic-in-memory architectures that are not possible with silicon technology. Although in its infancy, research in spintronics has been gaining momentum over the past decade, as these devices could potentially overcome the power bottleneck of CMOS scaling by offering a completely new computing paradigm. In recent years, progress has been made toward demonstration of various post-CMOS spintronic devices including all-spin logic, spin wave devices, domain wall magnets for logic applications, and spin transfer torque magnetoresistive RAM (STT-MRAM) and spin-Hall torque (SHT) MRAM for memory applications.
Flexible electronics: Distributed large area (cm2-to-m2) electronic systems based on flexible thin-film-transistor (TFT) technology are drawing much attention due to unique properties such as mechanical conformability, low temperature processability, large area coverage, and low fabrication costs. Various forms of flexible TFTs can either enable applications that were not achievable using traditional silicon based technology, or surpass them in terms of cost per area. Flexible electronics cannot match the performance of silicon-based ICs due to the low carrier mobility. Instead, this technology is meant to complement them by enabling distributed sensor systems over a large area with moderate performance (less than 1 MHz).